KREIDEZEIT Hard Oil light is a hard-wearing protection for many interior surfaces.KREIDEZEIT Hard Oil light does not contain any solvents or water, and consists exclusively of natural oils and resins. It contains no ‘hidden’ alkyd resins produced from non-drying oils
such as rapeseed, soybean or sunflower oil. In addition, the use of titanium dioxide has also been deliberately avoided in this product; the whitening effect comes exclusively from the use of zinc sulphide.
Properties
- dirt and water-resistant
- Solvent and water-free, very economical
- Doesn’t tear or become brittle
- Diffusible, antistatic and warm to touch
- Transparent
- Excellent penetration
- Easy to work with and touch up
- Saliva and sweat-resistant according to DIN 53160
- Cobalt, lead and barium-free
- Vegan
Full declaration
Linseed oil, linseed stand oil, tung stand oil, castor stand oil, glycerol ester of wood rosin, carnauba wax, zinc sulphide, manganese drier.
When using the product, the complete Productinformation Hard Oil Light must be observed.
Application
Stir the product before use. Apply two coats of KREIDEZEIT Hard Oil light, allowing the first coat to dry before applying the second. The substrate may require sanding before applying the second coat. It is recommended to dilute the product with at least 20% Balsamic Turpentine (article no. 4301) for the first coat on very dense, poorly absorbent and tannin-rich wood (such as oak).
If using containers with different batch numbers, mix and stir together prior to application. The product must not be pouredonto surfaces! Clean and dust down untreated substrates.
1. Initial sanding
Sand the wood (grit P80-100), rounding the edges. Do not use a finer sandpaper as this will make the wood too dense and unable to absorb enough oil. New, smooth, planed or finely pre-sanded wood should be rough sanded to ensure the oil can be absorbed.
Dust down thoroughly after sanding.
2. First coat
a) Manual application: Apply KREIDEZEIT Hard Oil light evenly with a brush, short-pile roller, cloth or sponge. After 10-20 minutes, thoroughly wipe the entire treated area with a dry, lint-free cloth until the surface has a uniform satin appearance.
b) Machine application:
Apply KREIDEZEIT Hard Oil light with a short-pile roller. After 10-20 minutes, thoroughly wipe the entire treated area with a soft pad until the surface has a uniform satin appearance. Change pad promptly once it becomes saturated.
Ensure that all unabsorbed oil has been completely removed, as otherwise shiny or sticky patches may remain. KREIDEZEIT Hard Oil light must fully penetrate into the wood. It must not form a layer on the wood.
3. Re-sanding between coats (optional)
Re-sanding between coats is only required if the surface has dried rough, for example if wood fibres have dried proud of the surface. Use sand paper (grit P180-240) in the direction of the fibre.Dust down thoroughly after sanding.
4. Second coat:
Repeat as per the first coat. Apply the product undiluted.
5. Wax treatment
Oiled surfaces generally do not require wax treatment. To improve the gloss, you can finish with Kreidezeit Carnauba Wax Emulsion (article no. 5105) after at least 48 hours. To do this, dilute 1 part emulsion with 2 parts water. Apply evenly and thinly, allow to dry and polish as
needed.
to dealerlist
If there is no dealer in your region, you can order directly from us under +49 5060 – 6080650 or under info@kreidezeit.de.
Please do not hesitate to contact us if you have any further questions.
