Resin Oil

Packing size 0,5 l
Range -
Consumption per m² -
Exact application rate values must be determined on site.

Special primer for highly absorbent wood, in particular end grains, beam heads and cutting edges, in indoor and outdoor areas. To be applied before Kreidezeit Wood Lazure or Stand Oil Paint. Also suitable as raw material for mixing oil varnishes and oil paints according to own recipes.

KREIDEZEIT Resin Oil consists of glycerol ester of wood rosin dissolved in balsamic turpentine. In our region, wood rosin is traditionally used to produce natural paints. It is extracted from living pine trees and is a renewable raw materials. If professionally tapped, a large pine tree can supply up to 4 kg of resin a year. This amount of resin can be extracted for up to ten consecutive years. The resin is separated by distillation into the volatile Balsamic Turpentine and the remaining solid part of the wood rosin. To improve the water resistance and hardness of the wood rosin, it is boiled with glycerin.



  • Highly water-resistant
  • Quick-drying
  • Physically dries as the solvent evaporates
  • Greatly reduces absorbency
  • Solvent-based, very economical
  • Transparent, honey-toned and colour-deepening
  • Cobalt, lead and barium-free
  • Vegan


Full Declaration

Balsamic turpentine and glycerol ester of wood rosin (approx. 40%)

When using the product, the complete Productinformation must be observed.

Warning! There is a risk of self-ignition when working materials are soaked with product.

Remove any resin pockets and old synthetic resin-based coats. Sand down new or weathered wood (grit P80-100), rounding the edges. Do not use a finer sandpaper as this will make the wood too dense and unable to absorb enough oil. New, smooth, planed or finely pre-sanded wood should be rough sanded to ensure the oil can be absorbed. Dust down thoroughly after sanding.
Soak absorbent cutting edges and end grain areas with Resin Oil and allow to dry for at least 24 hours.

Subsequent Coats
For outdoor use, KREIDEZEIT Wood Lazure or Stand Oil Paint must be applied after the Resin Oil.

Drying Time
Dust-dry after approx. 8 hours. Dry, sand and re-coat at 20°C and 60% relative humidy after approx. 24 hours. High humidity and cold temperatures significantly extend the drying time.

Suitable Tools
Paint brush / flat brush

Cleaning the Tools
Clean immediately after use with Balsamic Turpentine and then with Olive Care Soap or Corfu Soap.

Productinformation Resin Oil

Material Safety Data Sheet Resin Oil

to dealerlist

If there is no dealer in your region, you can order directly from us under +49 5060 – 6080650 or under
Please do not hesitate to contact us if you have any further questions.