Brush- and Roll-on Plaster is a lightly filling coat for interior use. Ideal for levelling out slight structural differences on plasterboard and gypsum fibre boards as well as repaired plasters. Gives smooth surfaces a fine plaster texture. Keeps the appearance of fine-grained rubbed plaster, which would inevitably disappear when painted over with smooth wall paints.
Wall and ceiling paint for interior use. Suitable for all structurally-sound, absorbent indoor renders (clay, lime, gypsum and cement), fillers, ingrain wallpaper, pure wallpaper, paper fleece, plaster-board, gypsum fibreboards and concrete.
Also suitable for firmly ingrained, matt and absorbent emulsion paints (please always test on a small sample area first.)
For wet rooms, we recommend KREIDEZEIT Lime Paint.
Properties
- Powder for mixing with water
- Fine plaster texture, grain 0.5 mm
- Ideal substrate for wall glaze techniques
- Levels out slight structural differences on the substrate
- Easy to use, structurable
- Very open to diffusion, antistatic
- Excellent opacity
- Natural white due to fine marble powder
- Without Titanium White
- Wiping resistant and several times overcoatable
- All ingredients from natural sources
- Free of antidegradants
- Free of synthetic resin binders
Full Declaration
Marble powder, marble sand, chalk, casein, kaoline, cellulose, soda, methyl cellulose
When using the product, the complete Product information must be observed.
Primer
Apply a base coat to all renders, fillers, levelled drywall, concrete and old emulsion paints with Vega Primer or Casein Primer and leave to dry completely. Do not apply to paper fleece/wallpaper.
Intermediate Coating
For even opacity on high-contrast substrates, it is recommended to apply a diluted Casein Marble Paint in addition to the Casein Primer.
For this, mix 1 kg of Casein Marble Paint in 700 ml clean, cold water without clotting. Leave to soak for 30 minutes and stir again. Application with roller or paint brush. Consumption: approx. 80 – 100 g Casein Marble Paint (powder) per m².
Mixing the Plaster
Stir in the specified amount of powder into clean, cold water, until the mixture is smooth. Use a powerful drill with agitator. Leave to expand for at least 30 minutes and stir well again before processing.
Application
Application temperature at least 8°C. Stir occasionally during application.
Two coats are typically required for full opacity. Do not attempt to cover dark and high-contrast substrates with only one coat of paint; excessive application thicknesses can lead to damage to the coating! Allow previous coats to dry completely before applying another coat. During the application, the wet paint is translucent; it only becomes fully opaque once drying is complete.
Using a paint brush Apply evenly with a facade brush in a criss-cross pattern.
Using a roller Apply the paint liberally and evenly in a criss-cross pattern. Then immediately use a roller in a single direction, without applying any further paint.
The Paint must be applied on the same day as mixing. Do not use paint that smells bad or rotten under any circumstances: Danger of prolonged odour problems even after drying!
Drying Times at normal Climate
Safe to coat after approx. 8 hrs.
Thoroughly dried after approx. 24 hrs.
Suitable Tools
Good quality, medium-pile paint roller (polyamide) and paint brush. Airless sprayers (min. air pressure 200 bar).
Recommended from the KREIDEZEIT range: Facade brush, Lime brush, Professional roller
Cleaning the Tools
Immediately after use with water.
The product can be tinted with up to 10% KREIDEZEIT earth and mineral pigments (max. 100 g pigment per 1 kg paint powder).
• Colour Chart
• Pigment guide Wall Paints and Renders
Either stir the pigment directly into the preparation water until smooth before mixing in the white Paint powder, or create a paste with a little water and then mix in with the finished Paint. Instruction
Printed versions of the Colour Charts are available from KREIDEZEIT and KREIDEZEIT dealers.
We would like to point out that the color tones cannot always be displayed correctly by different monitors and their settings. The same applies to self-produced prints of these colours. In order to get a better or true-to-original impression of our colours, we recommend the purchase of our colour cards with original coats or our printed, free flyers.
to dealerlist
If there is no dealer in your region, you can order directly from us under +49 5060 – 6080650 or under info@kreidezeit.de.
Please do not hesitate to contact us if you have any further questions.